Felder | FS 900 K Edge Sander
Precision Edge Sanding for Professional Results
The Felder FS 900 K Edge Sander delivers clean and precise edge sanding for wood and panel materials. Featuring an oscillating sanding belt, a continuously adjustable tilting table (90°–45°), and a height-adjustable table, it ensures efficient edge processing and extended belt life with a robust cast iron table and open design for long workpieces.
Key Features
Highlights
- Oscillating Sanding Belt: Independent oscillating motor maximizes 5⅞" (150 mm) belt width usage, enhancing durability and sanding quality.
- Tiltable Sanding Table: Adjusts from 90° to 45° for precise angular sanding.
- Height-Adjustable Table: 5⅞" (150 mm) adjustment for optimal belt utilization and versatility.
Details
- Additional Table and Sanding Shaft: Optional table (14.0.951) and sanding shaft/drum (14.0.952) for curved and radius sanding.
- Table Extension: Optional lowerable and extendable table (14.0.950), retrofittable to other Felder machines, for oversized workpieces.
- Belt Drive Rollers: 3⅛" and 6¼" diameter rollers ensure smooth belt operation at 11 m/sec (optional 8 or 11 m/sec with 2-speed motor).
- Dust Extraction: 120 mm connection with optional below-table extraction for efficient chip removal.
- Optional Rolling Carriage: Enhances mobility for flexible workshop setups.
Technical Specifications
| Category | Details |
|---|---|
| Electrics |
|
| Sanding Unit |
|
| General |
|
| Accessories |
|
| Transport |
|
Specifications
Felder FS 900 K Edge Sander FAQ
What is the FS 900 K?
An FS 900-series edge sander.
What is the sanding-belt speed?
11 m/s.
Can the sanding table tilt?
Yes; the sanding table tilts continuously for angled sanding.
Can table height be adjusted?
Yes, the sanding table is height-adjustable.
What belt length is compatible?
2,200 mm.
What belt width is compatible?
The same compatible belt measures 150 mm wide.
What K120 replacement belt is available?
Paper-backed belt article 14.2.0655, 2200×150 mm.
What abrasive does that belt use?
Corundum on a paper backing.
Is the belt listed for K and KF?
Yes, both FS 900 K and FS 900 KF are named.
What grit is suggested for fine raw wood?
Felder’s abrasive guide lists 150–240.
What grit is suggested for rough presanding?
The guide lists 70–120 for raw wood.
What grit is suggested for coating removal?
The guide lists 30–60 for glue and paint layers.
What grit is suggested for resanding coatings?
The table lists 280–600 for primed or painted surfaces.
Does the K include the KF's veneer device?
The KF includes the veneer device; confirm whether the quoted K machine has this equipment.
Which electrical rating should be used?
Use the machine's nameplate and quoted electrical setup; K and KF configurations should be checked individually.